MAKTUB HANDLE【ENG】

Installation Steps (A 10 mm socket wrench is required.) Step 1. Remove the original handle Tighten the star drag completely and remove the stock handle. Step 2. Remove the center cap Loosen the screw that secures the center cap on the handle body and remove the cap. Step 3. Attach the new handle Mount the Maktub handle onto the reel body. Step 4. Tighten the hex nut Use the included hex nut to secure the handle firmly to the reel body. For right-hand models: use the right-hand nut (no line). For left-hand models: use the left-hand nut (red line). ⚠️ Important: Always thread the nut lightly by hand first to avoid cross-threading, then finish tightening with a 10 mm socket wrench. Do not overtighten, as this may damage the reel. Step 5. Reinstall the center cap Attach the center cap and tighten the screw with the included Phillips (+) screwdriver. Adjust the hex nut so the cap can be fastened smoothly. Do not force the cap into place. If it cannot be removed, insert a flathead (–) screwdriver into the gap and gently pry it off. Depending on the reel model, the standard center cap may not fit. In this case, please use the separately sold deep-hole center cap. Included Parts Right-hand nut (no line) Left-hand nut (red line) Phillips (+) screwdriver for M2 screws (All included parts are packed inside the package.) Tools Required 10 mm socket wrench (Allen key)